RO Membrane Housing 1/8"
Membrane Housing for Standard RO Membranes:
The RO Membrane Housing can be used with most 11.75" to 12" reverse osmosis membrane elements.
This reverse osmosis membrane housing has a thicker body for stronger durability and stronger membrane cup design to prevent cracking.
The RO membrane housing has three standard 1/8” threaded ports. If you do not have fittings, see the Instructions section for available fittings.
This Reverse Osmosis Membrane housing utilizes a flat gasket and an o-ring to ensure a true double o-ring seal. Other RO membrane housings lacking one o-ring will leak.
You do not have to worry about bypass of Brine water to the Permeate side which is quite common on most other housings manufactured today.
The reverse osmosis membrane housing has been Tested and Certified by NSF International to NSF/ANSI Standard 42 for material and structural integrity requirements only.
Membrane housing materials of constructions:
Maximum temperature: 125°F (51.7°C)
Maximum pressure: 100 PSI (7 BAR)
Inlet/outlet: 1/8" FPT
Reverse Osmosis Membrane Housing can be used with:
RO Systems using a 11.75" to 12" Reverse Osmosis Membrane. 11.75" to 12" long RO Membranes are the standard size.
RO membranes that can be used in this RO Membrane Housing: TFM-18, TFM-24, TW30-1812-36, TFM-50, TW30-1812-75, TFM-100, Please call or email if your not sure.
If you do not have a standard size RO membrane, you can easily replace your membrane housing with this membrane housing. Standard RO Membranes are usually less expensive than special proprietary sized membranes.
If you have a manifold system, you will not be able to replace your membrane with this membrane housing and a new membrane. A manifold system is one that makes the connections in the plastic head without using tubing to connect the separate components. Manifold systems must use the original size membrane.